Hks evc 6 manual english

Quick Manual ELECTRONIC VALVE CONTROLLER types Turn on the EVC-S @To turn on (or off) the EVC-S, press the center of the switch longer @ Press the right side of the switch to set the Response Value. ("RSP" appears on the monitor.) RSP Boost n Increase ('Q Press the upper or lower side of the switch to enter a number. Decrease the Response Va lue.  · About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators.  · A few notes before installing: If you have any other HKS EVC, or HKS EZ, you will have to use the stepping motor included with the EVC 6, all other versions of the stepping motor are incompatable with the EVC 6. - Just as was the case with the stepping motor, None of the wiring is the same for the EVC 6. You will need to completely remove.

About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators. seconds of powering on the EVC. Load Parameter Select "Load Parameter" to load all parameter data from the EVC. * Loading cannot be performed if the initial setup is not complete or during the first few seconds of powering on the EVC. Send All Data Select "Send All Data" to send all map and parameter data edited from the EasyWriter. Quick Manual ELECTRONIC VALVE CONTROLLER types Turn on the EVC-S @To turn on (or off) the EVC-S, press the center of the switch longer @ Press the right side of the switch to set the Response Value. ("RSP" appears on the monitor.) RSP Boost n Increase ('Q Press the upper or lower side of the switch to enter a number. Decrease the Response Va lue.

The ONLY difference between the HKS connection diagram for EVC 3/4 (shown above with the blue ink english on top of the grey japanese) and the EVC5/6 is that the EVC3/4 diagram shows that the OUT port #3 is the center port of the 3 ports on the older solenoid piece, while the EVC 5/6 diagram shows that the OUT port #3 is on the top edge of the solenoid, with the IN port #2 in the center position. seconds of powering on the EVC. Load Parameter Select "Load Parameter" to load all parameter data from the EVC. * Loading cannot be performed if the initial setup is not complete or during the first few seconds of powering on the EVC. Send All Data Select "Send All Data" to send all map and parameter data edited from the EasyWriter. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators.